DCI2X600N-U-USFX vs DCI4X300-U-USFX — Compare
Crown DCI2X600N DCI2X600 Network vs Crown DCI4X300 DCI4X300 Analog
The Crown DCI2X600N is a networked, DSP-equipped 2-channel amp for centrally managed installed systems, while the DCI4X300 is a straightforward analog 4-channel amp built for touring and flexible live rigs. Choose the DCI2X600N if you need remote monitoring and integrated processing; choose the DCI4X300 if you want simplicity, multiple independent channels, and portability.
No sales tax on orders shipped outside California — total cost beats national retailers that charge sales tax in nearly every state.
Specs side by side
| Crown DCI2X600N DCI2X600 Network | Crown DCI4X300 DCI4X300 Analog | |
|---|---|---|
| Price | $3,296.00 | $2,810.00 |
| Brand | Crown | Crown |
| Power | 2 x 300W @ 4Ω | 300W @ 4Ω |
| Channels | 2 | 4 |
| Install Type | Installed | Installed |
| Condition | New | New |
Why choose Crown DCI2X600N DCI2X600 Network
- ✓ Integrated DSP with crossovers, EQ, delay, and matrix mixing—no external processor needed
- ✓ HiQnet remote monitoring and control via TCP/IP for centralized system management
- ✓ Exceptional thermal stability (549 BTU/hr) for confined rack spaces without active cooling
- ✓ Preset storage for rapid multi-venue deployment
Why choose Crown DCI4X300 DCI4X300 Analog
- ✓ 4 independent channels for maximum flexibility in speaker configuration and routing
- ✓ Extremely tight damping factor (>1000) delivers accurate bass response and speaker control
- ✓ Ultra-low distortion (0.35% THD) and clean amplification across the audible spectrum
- ✓ Simple analog interface with no networking complexity—faster setup and troubleshooting in live environments
Frequently asked questions
Which amp is better for a touring live sound rig?
The DCI4X300. Its 4 independent channels, analog simplicity, and rugged design make it ideal for traveling between venues. The DCI2X600N's networking strength is realized in permanent installations where remote management across multiple locations matters.
Do I need an external DSP unit with the DCI4X300?
Yes, if you want crossovers, EQ, or delay processing. The DCI4X300 is pure amplification. The DCI2X600N includes all that DSP onboard and configurable over the network, so you can skip external gear.
Which delivers more total output power?
The DCI2X600N: 600W per channel × 2 channels equals 1200W total. The DCI4X300: 300W per channel × 4 channels equals 1200W total. Same total, but the DCI2X600N concentrates it in two very powerful channels while the DCI4X300 spreads it across four moderate channels.
Can I use either amp for both 70V/100V distributed systems and low-impedance speakers?
Yes—both support 70V, 100V, and 2Ω–16Ω loads. The main difference is that the DCI2X600N configures this centrally via network, while the DCI4X300 uses manual Hi-Z/Low-Z switches on each channel pair.